Goulds HT Goulds Pumps. Goulds HT High -Temperature Process Pumps with. Patented Intelligent Monitoring. Lenntech [email protected] Tel. Goulds Pumps. Goulds LF Low Flow ANSI Process Pumps with. Patented Intelligent Monitoring. Lenntech [email protected] Tel. + Goulds Models , CV , HT , LF , NM , , and unless written approval is obtained in advance from Goulds Pumps.
|Published (Last):||9 December 2014|
|PDF File Size:||15.62 Mb|
|ePub File Size:||4.18 Mb|
|Price:||Free* [*Free Regsitration Required]|
Do you have a better or corrected version of this model? Loosen the jam nuts on the jack bolts Dand then back the bolts out about two turns.
Always disconnect and lock out 31996 to the driver before you perform any installation or maintenance tasks. Download Download the model according to the specified sizing parameters in either 3D or 2D format. Configuring model for download. This tag promotes violence or is hateful.
Notify me by email of any comments added to content I uploaded.
Gould MTi 2 x Description: It”s little bigger for my need,it will be better if there are multiple sizes. Please hit “OK” to reload the page and then try again. Create a New Catalog. Commissioning, Startup, Operation, and Shutdown. Improperly setting the clearance or not. Valid email address is required to complete registration. Thanks, saved me some time in my assembly layout.
Goulds Pumps i-FRAME – IOM User Manual | pages
Impeller clearance methods You can set the impeller clearance with either of these ;umps This tag is otherwise inappropriate. Set the indicator to zero and loosen the locking bolt C about one turn. Add this User to “My Favorites”. Notify me by email when my requests are filled by the user community.
Goulds Pumps 3196 i-FRAME – IOM User Manual
A validation email will be sent to the new email address and you will need to click the confirmation link in the email to activate your account. Failure to gouods so could result in sparks, heat generation, and mechanical seal damage.
Tighten the locking bolts evenly Cbringing the bearing housing A towards the frame until gouds impeller contacts the casing. Gould Centrifugal Pump By: Configure Change the options below to customize the model for downloading.
3D ContentCentral – Free 3D CAD Models, 2D Drawings, and Supplier Catalogs
Model ready for download. Post Alternate Version Login required. Tighten the jack bolts evenly about one flat at a time, moving the bearing housing A away from the bearing frame until the indicator shows the correct clearance. Complain wrong Brand wrong Model non readable.
Units Zipped Download all configurations Remind me to rate this model. Gould MTi 2 x sw Add this Part to “My Favorites”. Failure to disconnect and lock out driver power will result in serious physical injury. Send this page to a friend. Do you have a different version of this model?
You are about to permanently delete a catalog. Tighten the locking bolts evenly Cbringing the bearing housing A towards the frame Impeller-clearance setting Importance of a proper impeller clearance A proper impeller clearance ensures that the pump runs at high performance.
Set the impeller clearance – dial indicator method all except CV This model saved me a lot of work, ideal for mockups and layouts. Set the indicator so gohlds the button contacts either the shaft end or the face of the coupling. Current Profile Picture Only. Thread in the jack bolts D until the jack bolts 31996 contact the bearing frame.
Gould Supplier part number: Content from this User. Click the Update Preview button to apply your changes to the viewer.
Model is not in correct dimension.